DAVID
SHPB tests analysis software
Features
David software provides a complete processing for SHPB tests. It has been designed to perform an analysis of the numerical data in the form of the stored voltage signals from two gauge stations glued on both bars. These bars and the striker are made of possibly different materials and diameters, including low impedance viscoelastic bars. The most recent features included in the program are:
– dispersion correction including the case of viscoelastic bars;
– precise shifting assisted by the simulation of the initial elastic response of the specimen;
– calibration procedures based on energy and momentum balance (striker/input bar and input bar/output bar).
A correction of bar punching by the specimen is available.
Specimens with shoulders are supported.
The fundamental results delivered by David are the speed and force at both specimen faces.
Derived from these results, a simplified Kolsky type analysis is available. It is based on the assumption of specimen equilibrium using any couple of the 3 basic waves (incident, reflected and transmitted) to deliver specimen stress and strain. A better analysis is proposed by David, deriving the strain from the speeds at both specimen faces and the stress from the output force, or the average between the input and the output force.
The subsequent treatment is standard. It can take into account the friction at specimen ends and lateral inertia effects using empirical formulas found in the literature and established in the particular case of elastoplastic specimens. It provides stress, strain, strain-rate (engineering and true) and absorbed energy to be possibly used for thermal analysis.
Download 32 bits 16004 version, for "old" PCs.
DAVID requires the LabVIEW® RunTime Engine version 2015
Download LabVIEW 2015 runtime engine
The full version of DAVID (16004) can be downloaded here:
Download DAVID 16004 full version
Download 64 bits 230703 version
The full version of DAVID can be downloaded here:
Download DAVID 230703 full version
Extract all the files and run setup.exe. The required LabVIEW runtime will be automatically installed if necessary.
To request a licence, run the program David_Key, and follow the instructions.
Please note that it is recommended to remove any previous version of David before installing this new one.
Tips
As “demonstration files” are written with the English separator (decimal point), it is necessary to set the “country parameters” on your computer to the English version or equivalent.