GNUBLIN


Smartrap

GNUBLIN-Standard


File:Gnublin.jpg


  • ARM9 Processor at 180 MHz (LPC3131)
  • 32 MB SDRAM
  • microSD card for bootloader, kernel, filesystem and swap partition
  • USB-Device or USB-Host connector (configurable with jumpers)
  • 3 x GPIO
  • 3 x ADC
  • 1 x PWM
  • 1 x SPI
  • 1 x I2C
  • 1 x USB-RS232 converter for serial terminal
  • 1 x Red LED
  • 1 x Power-LED
  • different boot options (SD-card, USB or RS232)
  • external power supply possible (7 - 12V DC)
  • about 60-70mA at boot time and run time
  • about 30-50mA in idle state
  • Reset button
  • And last but not least: everything is open-source!

GNUBLIN-Extended

Extended schraegbild.jpg
  • ARM 9 processor at 180 MHz
  • 32 MB SDRAM
  • microSD card (up to 32 GB) operating system,kernel,user data
  • 15 x GPIO, 4 x ADC, UART, SPI, I2C, i2S (Audio), MCI (for SD and MMC-cards),
  • data and address lines avialable on 2x60 pole rail
  • 1 x Hardware PWM
  • SPI and I2C avialable on 2x7 pole connector
  • JTAG 10 pole (backside 10 pole SMD)
  • 1 x red LED
  • Power-LED
  • different boot options selectable by jumpers (SD-card, USB or RS232)
  • External 7- 12 V power supply possible
  • Reset button
  • USB-OTG (Host or Device)

GNUBLIN-DIP

File:GNUBLIN-DIP.JPG

  • 180 MHz
  • 8 or 32 MB RAM
  • Boot from SD-Card (up to 16 GB)
  • USB OTG (Host or Device)
  • 15 X Digital in and outputs
  • 4 x Analogue inputs
  • I2C
  • SPI
  • PWM
  • Simple 5V power supply
  • power consumption about 100mA full load (5V power supply) -> 0.5 Watts

GNUBLIN Module-GnuPi

RASPBERRY-BRIDGE schraeg bestueckt.JPG



Website
Wiki
Shop